mvebu: enable thermal zone polling for IEI Puzzle devices

Marvell's thermal sensors do not support interrupts, so we need to
poll them. Reading temperature every second should be enough to
control the fan.
While at it, also make sure fan speed is reduced again if temperature
goes down.

Signed-off-by: Daniel Golle <daniel@makrotopia.org>

diff --git a/target/linux/mvebu/files/arch/arm64/boot/dts/marvell/puzzle-thermal.dtsi b/target/linux/mvebu/files/arch/arm64/boot/dts/marvell/puzzle-thermal.dtsi
index 94677532f2dc1f341ca5c9953272db9baa7bab1f..a8ce8fd102c69614de541f54780169b504a6ebde 100644 (file)
--- a/target/linux/mvebu/files/arch/arm64/boot/dts/marvell/puzzle-thermal.dtsi
+++ b/target/linux/mvebu/files/arch/arm64/boot/dts/marvell/puzzle-thermal.dtsi
@@ -1,4 +1,7 @@
 #define PUZZLE_FAN_THERMAL(_cname, _fan)                                       \
+       polling-delay-passive = <500>;                                          \
+       polling-delay = <1000>;                                                 \
+                                                                               \
        trips {                                                                 \
                _cname##_active_high: cpu-active-high {                         \
                        temperature = <80000>;                                  \
@@ -28,14 +31,14 @@
                };                                                              \
                cpu-active-med {                                                \
                        trip = <&_cname##_active_med>;                          \
-                       cooling-device = <_fan 2 THERMAL_NO_LIMIT>;             \
+                       cooling-device = <_fan 2 3>;                            \
                };                                                              \
                cpu-active-low {                                                \
                        trip = <&_cname##_active_low>;                          \
-                       cooling-device = <_fan 1 THERMAL_NO_LIMIT>;             \
+                       cooling-device = <_fan 1 2>;                            \
                };                                                              \
                cpu-active-idle {                                               \
                        trip = <&_cname##_active_idle>;                         \
-                       cooling-device = <_fan 0 THERMAL_NO_LIMIT>;             \
+                       cooling-device = <_fan 0 0>;                            \
                };                                                              \
        }