openwrt/usteer/files/etc/config/usteer

   1 config usteer
   2         # The network interface for inter-AP communication
   3         option 'network' 'lan'
   4
   5         # Log messages to syslog (0/1)
   6         option 'syslog' '1'
   7
   8         # Disable network communication (0/1)
   9         option local_mode '0'
  10
  11         # Use IPv6 for remote exchange
  12         option 'ipv6' '0'
  13
  14         # Minimum level of logged messages
  15         # 0 = fatal
  16         # 1 = info
  17         # 2 = verbose
  18         # 3 = some debug messages
  19         # 4 = network packet information
  20         # 5 = all debug messages
  21         option 'debug_level' '2'
  22
  23         # Maximum number of neighbor reports set for a node
  24         #option max_neighbor_reports 8
  25
  26         # Maximum amount of time (ms) a station may be blocked due to policy decisions
  27         #option sta_block_timeout 30000
  28
  29         # Maximum amount of time (ms) a local unconnected station is tracked
  30         #option local_sta_timeout 120000
  31
  32         # Maximum amount of time (ms) a measurement report is stored
  33         #option measurement_report_timeout 120000
  34
  35         # Local station information update interval (ms)
  36         #option local_sta_update 1000
  37
  38         # Maximum number of consecutive times a station may be blocked by policy
  39         #option max_retry_band 5
  40
  41         # Maximum idle time of a station entry (ms) to be considered for policy decisions
  42         #option seen_policy_timeout 30000
  43
  44         # Minimum number of stations delta between APs before load balancing policy is active
  45         #option load_balancing_threshold 0
  46
  47         # Minimum number of stations delta between bands before band steering policy is active
  48         #option band_steering_threshold 5
  49
  50         # Interval (ms) between sending state updates to other APs
  51         #option remote_update_interval 1000
  52
  53         # Number of remote update intervals after which a remote-node is deleted
  54         #option remote_node_timeout 10
  55
  56         # Allow rejecting assoc requests for steering purposes (0/1)
  57         #option assoc_steering 0
  58
  59         # Allow ignoring probe requests for steering purposes (0/1)
  60         #option probe_steering 1
  61
  62         # Minimum signal-to-noise ratio or signal level (dBm) to allow connections
  63         #option min_connect_snr 0
  64
  65         # Minimum signal-to-noise ratio or signal level (dBm) to remain connected
  66         #option min_snr 0
  67
  68         # Timeout after which a station with snr < min_snr will be kicked
  69         #option min_snr_kick_delay 5000
  70
  71         # Timeout (ms) for which a client will not be steered after rejecting a BSS-transition-request
  72         #option steer_reject_timeout 60000
  73
  74         # Timeout (in ms) after which a association following a disassociation is not seen
  75         # as a roam
  76         #option roam_process_timeout 5000
  77
  78         # Minimum signal-to-noise ratio or signal level (dBm) before attempting to trigger
  79         # client scans for roaming
  80         #option roam_scan_snr 0
  81
  82         # Maximum number of client roaming scan trigger attempts
  83         #option roam_scan_tries 3
  84
  85         # Retry scanning when roam_scan_tries is exceeded after this timeout (in ms)
  86         # In case this option is set to 0, the client is kicked instead
  87         #option roam_scan_timeout 0
  88
  89         # Minimum time (ms) between client roaming scan trigger attempts
  90         #option roam_scan_interval 10000
  91
  92         # Minimum signal-to-noise ratio or signal level (dBm) before attempting to trigger
  93         # forced client roaming
  94         #option roam_trigger_snr 0
  95
  96         # Minimum time (ms) between client roaming trigger attempts
  97         #option roam_trigger_interval 60000
  98
  99         # Timeout (ms) for client roam requests. usteer will kick the client after this times out.
 100         #option roam_kick_delay 10000
 101
 102         # Minimum signal strength difference until AP steering policy is active
 103         #option signal_diff_threshold 0
 104
 105         # Initial delay (ms) before responding to probe requests (to allow other APs to see packets as well)
 106         #option initial_connect_delay 0
 107
 108         # Enable kicking client on excessive channel load (0/1)
 109         #option load_kick_enabled 0
 110
 111         # Minimum channel load (%) before kicking clients
 112         #option load_kick_threshold 75
 113
 114         # Minimum amount of time (ms) that channel load is above threshold before starting to kick clients
 115         #option load_kick_delay 10000
 116
 117         # Minimum number of connected clients before kicking based on channel load
 118         #option load_kick_min_clients 10
 119
 120         # Reason code on client kick based on channel load (default: WLAN_REASON_DISASSOC_AP_BUSY)
 121         #option load_kick_reason_code 5
 122
 123         # Attempting to steer clients to a higher frequency-band every n ms.
 124         # A value of 0 disabled band-steering.
 125         #option band_steering_interval 120000
 126
 127         # Minimal SNR or absolute signal a device has to maintain over band_steering_interval to be
 128         # steered to a higher frequency band
 129         #option band_steering_min_snr -60
 130
 131         # Interval (ms) the device is sent a link-measurement request to help assess
 132         # the bi-directional link quality. Setting the interval to 0 disables link-measurements.
 133         #option link_measurement_interval 30000
 134
 135         # Script to run after bringing up a node
 136         #option node_up_script ''
 137
 138         # Message types to include in log
 139         # Available types:
 140         # - probe_req_accept
 141         # - probe_req_deny
 142         # - auth_req_accept
 143         # - auth_req_deny
 144         # - assoc_req_accept
 145         # - assoc_req_deny
 146         # - load_kick_trigger
 147         # - load_kick_reset
 148         # - load_kick_min_clients
 149         # - load_kick_no_client
 150         # - load_kick_client
 151         # - signal_kick
 152         #list event_log_types ''
 153
 154         # List of SSIDs to enable steering on
 155         #list ssid_list ''