From 7dd42d610dcd6f9271d5d44edff52caf633b8abf Mon Sep 17 00:00:00 2001 From: Mathias Kresin Date: Wed, 21 Dec 2016 09:59:29 +0100 Subject: [PATCH] lantiq: add FRITZ7360SL phy reset gpios Due to a hardware bug of Atheros 8030 phys, the driver need to reset the phys on link state change. Use the correct compatible string for the at903x phys connected to switch port 0 and 1. Fix the pinmux of the gpio lines connected to the reset pin of the phys and define the reset-pins to let the driver do the fixups. Fixes FS#343 Signed-off-by: Mathias Kresin --- target/linux/lantiq/dts/FRITZ7360SL.dts | 10 +++++----- 1 file changed, 5 insertions(+), 5 deletions(-) diff --git a/target/linux/lantiq/dts/FRITZ7360SL.dts b/target/linux/lantiq/dts/FRITZ7360SL.dts index b3cb1c524147..0caea7fe711b 100644 --- a/target/linux/lantiq/dts/FRITZ7360SL.dts +++ b/target/linux/lantiq/dts/FRITZ7360SL.dts @@ -70,7 +70,7 @@ }; phy-rst { lantiq,pins = "io37", "io44"; - lantiq,pull = <2>; + lantiq,pull = <0>; lantiq,open-drain; lantiq,output = <1>; }; @@ -160,14 +160,12 @@ reg = <0>; phy-mode = "rmii"; phy-handle = <&phy0>; - // gpios = <&gpio 37 GPIO_ACTIVE_LOW>; }; ethernet@1 { compatible = "lantiq,xrx200-pdi-port"; reg = <1>; phy-mode = "rmii"; phy-handle = <&phy1>; - // gpios = <&gpio 44 GPIO_ACTIVE_LOW>; }; ethernet@2 { compatible = "lantiq,xrx200-pdi-port"; @@ -189,11 +187,13 @@ compatible = "lantiq,xrx200-mdio"; phy0: ethernet-phy@0 { reg = <0x00>; - compatible = "lantiq,phy11g", "ethernet-phy-ieee802.3-c22"; + compatible = "ethernet-phy-id004d.d076", "ethernet-phy-ieee802.3-c22"; + reset-gpios = <&gpio 37 GPIO_ACTIVE_LOW>; }; phy1: ethernet-phy@1 { reg = <0x01>; - compatible = "lantiq,phy11g", "ethernet-phy-ieee802.3-c22"; + compatible = "ethernet-phy-id004d.d076", "ethernet-phy-ieee802.3-c22"; + reset-gpios = <&gpio 44 GPIO_ACTIVE_LOW>; }; phy11: ethernet-phy@11 { reg = <0x11>; -- 2.30.2