3 #include <dt-bindings/gpio/gpio.h>
4 #include <dt-bindings/input/input.h>
7 compatible = "belkin,f5d8235-v2", "ralink,rt3052-soc";
8 model = "Belkin F5D8235 v2";
11 led-boot = &led_router;
12 led-failsafe = &led_router;
13 led-running = &led_router;
14 led-upgrade = &led_router;
18 compatible = "cfi-flash";
19 reg = <0x1f000000 0x800000>;
24 compatible = "fixed-partitions";
29 compatible = "nvmem-cells";
36 eeprom_uboot_40000: eeprom@40000 {
37 reg = <0x40000 0x200>;
40 macaddr_uboot_40004: macaddr@40004 {
46 compatible = "denx,uimage";
48 reg = <0x50000 0x790000>;
53 reg = <0x7e0000 0x10000>;
56 factory: partition@7f0000 {
58 reg = <0x7f0000 0x10000>;
64 compatible = "realtek,rtl8366rb";
65 gpio-sda = <&gpio0 1 GPIO_ACTIVE_HIGH>;
66 gpio-sck = <&gpio0 2 GPIO_ACTIVE_HIGH>;
70 compatible = "gpio-leds";
73 label = "blue:internet";
74 gpios = <&gpio0 5 GPIO_ACTIVE_LOW>;
78 label = "amber:internet";
79 gpios = <&gpio0 6 GPIO_ACTIVE_LOW>;
84 gpios = <&gpio0 11 GPIO_ACTIVE_LOW>;
88 label = "amber:modem";
89 gpios = <&gpio0 8 GPIO_ACTIVE_LOW>;
93 label = "blue:router";
94 gpios = <&gpio0 9 GPIO_ACTIVE_LOW>;
98 label = "blue:storage";
99 gpios = <&gpio0 23 GPIO_ACTIVE_LOW>;
100 trigger-sources = <&otg_port1>;
101 linux,default-trigger = "usbport";
105 label = "amber:storage";
106 gpios = <&gpio0 22 GPIO_ACTIVE_LOW>;
110 label = "blue:security";
111 gpios = <&gpio0 13 GPIO_ACTIVE_LOW>;
115 label = "amber:security";
116 gpios = <&gpio0 12 GPIO_ACTIVE_LOW>;
123 groups = "spi", "i2c", "jtag", "mdio", "uartf";
129 nvmem-cells = <&macaddr_uboot_40004>;
130 nvmem-cell-names = "mac-address";
131 pinctrl-names = "default";
132 pinctrl-0 = <&rgmii_pins>;
137 mediatek,portmap = <0x3f>;
138 ralink,fct2 = <0x0002500c>;
140 * ext phy base addr 31, rx/tx clock skew 0,
141 * turbo mii off, rgmi 3.3v off, port 5 polling off
142 * port5: enabled, gige, full-duplex, rx/tx-flow-control
143 * port6: enabled, gige, full-duplex, rx/tx-flow-control
145 ralink,fpa2 = <0x1f003fff>;
149 nvmem-cells = <&eeprom_uboot_40000>;
150 nvmem-cell-names = "eeprom";